LPG Regulator Installation Notice

LPG Regulator Installation Notice

In the installation of LPG pressure regulator, it is necessary to be cautious and regular operation. The specific installation requirements are as follows:

1. Before installing the Lpg Regulator, it is necessary to test and purge the pipeline to ensure the tightness and cleanliness of the pipeline.

2. LPG pressure regulator should be installed horizontally and vertically on the pipeline. When installing, attention should be paid to make the flow direction of the pipeline medium consistent with the direction of the arrow shown on the valve body.

3. The control ball valve should be installed on both sides of the LPG regulator, and the bypass pipe should be installed for maintenance.

4. Pressure gauges should be set on the high and low pressure pipelines of the LPG pressure regulator for easy adjustment, and the pressure changes before and after the valve can be observed in operation.
5. A safety release valve is set on the pipeline to ensure the reliability and safety of the LPG pressure regulator operation.

6. The indoor gas pipeline should be equipped with a gas leakage alarm device indoors to ensure that when the gas leakage is dangerous, it can alarm in time and eliminate the danger.

7, in order to ensure safe use, in the installed LPG pressure regulator, be sure to test the tightness, can be used in all pipe interface detection or brush soapy water, detergent water for inspection, observe whether there is air leakage. If there is a pressure gauge installed before and after the voltage regulator, you can turn off the air source and observe whether there is a change in the pointer.